单组份有机硅涂覆胶One component silicone conformal coating

SI1067 One Component Silicone Conformal Coating 

?Product Description

SI1067 is a low viscosity neutral silicone coating sealant, which is easy to apply by spraying, dipping, brushing or flow coating. For the protection of hard and soft printed circuit board and impregnation of porous substrate. To ensure the electronic products obtaining a stable state in the harsh conditions.

?Key Features

• 1. Single component, low viscosity, solvent-based

• 2. High transparency, room temperature cured

• 3. Various coating methods are applicable

• 4. After cured, have good elastic and stabilize at -60 - 200 °C, repairable

• 5. Bond very well with variety substrates, even without primer

• 6. Excellent waterproof, anti-corrosion, moisture proof, electrical insulation performance

• 
  

?Typical Applications

Widely used in rigid or flexible electronic circuits, can be used as coating protection for a thick membrane circuit and porous products; moisture protection for ceramics, can also be used in solar equipment manufacturing.

?Technical Data Table

Note：All above data were tested after curing under 25°C, 55% RH for 7 days, or tested by further experiments.

?Directions for Use

Spraying

1. Diluted by diluent 1067, the volume of diluent will affect the viscosity and thickness of the glue. (The more diluent added, the lower viscosity, the glue will be thinner; on the contrary, the higher viscosity, the thicker glue thickness).

2. Recommendations for the deployment of diluent 30% to 50%.

3. Recommendations anhydrous toluene, petroleum ether for diluent, should not use alcohols/ ketones solvents.

4. Transferred the diluted glue to a watering pot and be sprayed directly.

5. Use diluent to clean watering pot after spray.

6. Process the coating operation in a well ventilated space.

Dipping

1. Put the diluted glue in bucket to dip coating

2. To avoid bubbles the dipped speed of PCB immersion should not be too fast.

3. The tack-free time in the room temperature is about 40 minutes, heat stoving operation is not suggested.

4. When used again after the dip, if glue surface crusted, remove the epidermis can be continued to use.

?Packing and Storage

1 L/Bucket, 2.8 L/Can, 5 Gallon/ Bucket.

When stored at 25°C in the original unopened containers, this product has a usable life of 12 months from the date of production. Sampling test the products out of deadline before using.

These products are non-dangerous goods, can be transported and stored as normal chemicals.

?Safety Operation Data

MSDS isn't included here. Please read TDS, MSDS and label carefully before operation. You can get MSDS from SEPNA or other distributors, or mail to service center sepna@sepna.cc, or call +86-400-882-1323.

?Warranty and Liability

All product properties and application details based on information believe to be reliable and accurate. But you still need to test its property and safety before application. The advices we supply don't apply in any circumstances. SEPNA don't make assurance of any other applications outside the specification until SEPNA supply a special written guarantee. SEPNA is only responsible to replace or refund if this product is defective within the warranty period stated above. SEPNA makes it clear that will not be liable of any accidents.