X-Ray Fault Detector for Steel Cord conveyor Belt-Hand-Held type

1.Product Introduction· Hand-held X-ray fault detector is a small machine for perspective purpose by imaging with X-ray principle, which is specially used in mining companies.· By inserting the fault detector parallel to the ends of the upper and lower surfaces of the conveyor belt and switching on the power of fault detector, the wire cables inside the conveyor belt can be clearly displayed.· Different damages, such as wire breakage, wear, fatigue, rust and joint twitch, inside the steel-cord conveyor belt can be clearly detected through the display screen of the flaw detector, and the defective parts of the steel-cord can be photographed for storage and remote transmission.The detection site can be observed in time through the built-in display screen Remote observation can be realized through wireless connection with mobile phone/tablet/laptop2.Features and advantages :Small sizeL960mm*W430mm*T155mmLight weightThe weight of the detector is 8kg, and the total weight including the suitcase is 22kgClear imagingThe detection card, with a resolution of 50 lp/cm, can take the complete photo of every subtle link of the entire beltPictures can be storedThe detected damages can be photographed by pressing the shutter, with the damage data stored in the memory card in the form of pictures for easy playback and storageDiverse image viewing devicesThe detector transmits signals to image viewing devices, such as mobile phone/tablet/laptop, wirelessLow radiationRadiation at any angle 1M away from the X-ray tube will not jeopardize human healthLow priceIt is the cheapest X-ray fault detector for steel-cord conveyor belt on the marketPackage of the equipment3. Product Parameter:Performance parameterPenetrationStrong belt with a thickness no greater than 30mm can be penetratedDisplay DiameterΦ76mmOperating Voltage of the X-ray Tube75 kVOperating Current of the X-ray Tube0.4 mAImage Resolution≥40 line pairs/cmGray Scale≥10 LevelContrast≥4%Weight8kg/9kgTransmission between the Detector and the Image Viewing Devicewireless transmissionBattery Parameters24V, 1.5AHCharging Voltage220V AC, with a charging time of 4-6 hoursDetection Timeit can be continuously used for 60s each time, and the battery can last 40min4.Product Physical structure:  Product size and weight:There are two models of this products: Long-armed and Short-armedSpecificationsL*W*TDetection DepthDetection ThicknessDetection RangeWeight with SuitcaseNet WeightShort-armed960*430*155mm800mm30mmΦ76mm22.5kg8kgLong-armed1200x430x155mm1100mm30mmΦ76mm25.5kg9kg5.Comparison of advantages and disadvantages among the three types of X-ray detectors for steel-cord conveyor beltS/NDetection ContentFixedMobileHand-held1Whether it can detect the steel-cordin conveyor beltYesYesYes2Whether the image of the steel-corddetected is clearClearClearClear3Whether the conveyor belt needsto be shut down for detectionNo needNo needNeed4Conveyor belt area that can bedetected at each timeEntire beltEntire beltΦ76mm5Time required to detect acomplete conveyor belt20min-90min20min-90minUnable to detect a complete belt6Detection of wire cable breakage,rust and splitAccurateAccurateUnable to detect, only able to verify7Detection of joint twitch ofconveyor beltRelatively accurateRelatively accurateUnable to detect, only able to verify8Equipment priceHighHighLow9Purpose of the development ofthe device and target customersApplicable to the fixing, installation and real-time safety monitoring of the conveyor beltsin key transport links of mining enterprisesUsed by belt service providers to detect and maintainmultiple conveyor belts of the mining companiesUsed to verify and detect the defect ofconveyor belt found manuallyTest case